Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterTrusted Sliding & Patio Doors for Stuart Homeowners
A sliding glass door that sticks, drags, or lets humidity pour into your living room is a daily irritation and a signal that the frame has moved out of square. In Stuart, where salt air and summer heat work on rollers, tracks, and weatherstripping year-round, that irritation shows up early and gets worse fast. TruePane Windows & Doors has replaced, repaired, and reinstalled sliding and patio doors across Stuart since 2008 through a second-generation glazier’s craft tradition. We measure every opening twice, quote manufacturer lines side by side on paper, and stand behind the work with our Done Right Promise. If you have a slider that no longer slides, call (754) 324-4646 and a live person will answer.
What Our Sliding & Patio Doors Service Includes
Patio Sliding Doors
A patio sliding door is the workhorse of a Florida home, opened and closed a dozen times a day and expected to seal tight against rain and heat. Over time the rollers wear flat, the track fills with sand and shell grit, and the door starts to bind or jump. We replace worn rollers, straighten or replace bent tracks, adjust the strike plate so the latch actually catches, and set the panel square in its frame. Most patio slider repairs in Stuart are completed in a single visit, and we leave the door gliding with one hand, the way it did when the house was built.
Panoramic Sliding Systems
Panoramic sliding systems use multiple panels, often ceiling-height glass, to open an entire wall to the patio or pool deck. These are heavier units with tighter tolerances, and a quarter-inch settlement in the slab is enough to throw the whole run out of alignment. TruePane’s technicians work with multi-panel systems regularly, checking each panel for plumb, adjusting carrier assemblies, and ensuring every lock point engages. When a panoramic door binds in a Stuart home, the cause is rarely one bad roller, so we diagnose the full track run before touching a single panel.
Heavy-Duty Sliding Doors
Some sliders carry panels weighing two or three hundred pounds, especially impact-rated units built for hurricane code. Heavy-duty doors demand heavy-duty hardware: reinforced carriers, stainless tracks, and frames anchored to the rough opening rather than shimmed loosely. We install and repair these systems with the understanding that a 90-degree summer day in Stuart adds expansion stress that lighter hardware cannot absorb. If your door takes two hands and a shoulder to move, the hardware is either undersized for the panel or the frame has shifted, and we will find which before quoting a fix.
Pocket & Barn Doors
A pocket sliding door disappears into the wall, which means every repair has to account for the cavity it lives in. When a pocket door comes off its track inside a Stuart home, the problem is usually a broken top guide or a track bracket that pulled loose from the framing. We pull the door, inspect the cavity, repair the hardware, and rehang the panel so it travels without scraping the wall opening. Barn doors ride on exposed rails, and we install and service those as well, setting the standoff brackets and floor guides so the door hangs straight and stays put at both ends of travel.
Screen Door Installation
A sliding screen door keeps the bugs out and the breeze moving, and in Stuart it takes a beating from salt, wind, and daily use. Torn screening, bent frames, and rollers that grind against the track are the three most common failures we see. TruePane installs new sliding screen doors matched to the existing slider, builds replacement screen panels when the frame is sound, and adjusts the tension so the door closes on its own every time. We also supply and fit pet-resistant screen for homes where the animals push through before the owner reaches the handle.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Sliding & Patio Doors
We have serviced hundreds of PGT sliding doors across Stuart and Martin County, and we know their hardware families well enough to order the correct roller assembly on the first trip, not the third. PGT builds a heavy panel, especially in their impact lines, and the hardware has to be matched to the panel weight or the door will never roll right. TruePane is an authorized installer for PGT, so when a replacement is the better call, you see the full line quoted on paper before you spend a dollar.
CGI and Ply Gem are two other lines we regularly work on in Stuart. CGI’s impact sliders have a particular track profile and carrier style that require the right replacement parts, and we keep the common service components on the truck. Ply Gem units are common in older Stuart homes, and the most frequent repair there is a worn bottom track or a lock that no longer lines up with the strike. Whether you have one of these brands or any other make, we can help. The door tells us what it needs, and we know where to look.
Signs You Need Sliding & Patio Doors Right Now
- The door grinds or shudders when you push it. Rollers that have worn flat or filled with sand drag against the track instead of rolling over it. Every time that happens, the track gets scored a little deeper, and a repair that starts at a roller replacement turns into a full track change.
- You can see daylight around the panel when it is closed. That gap means the weatherstripping is crushed or the panel is no longer square in the frame. In Stuart’s summer humidity, that gap is also a wide-open path for moist air and the mildew that follows it.
- The handle no longer locks without lifting or forcing the door. When the strike plate and latch do not line up, the door has settled or the panel has sagged. Forcing the lock past the strike is a short-term workaround that bends hardware and wears out the lock body.
- Condensation collects inside the glass between the panes. A failed seal means the insulating gas has leaked out and moisture has gotten in. The glass is no longer doing its job, and in a sliding door that faces the afternoon sun, the room will heat up measurably.
- The door has gotten harder to open over the last six months. Progressive stiffness is a sign of spreading failure: a roller starting to bind, a track bending under the panel weight, or a frame moving out of square. Doors in Stuart do not heal themselves, and the problem is cheaper to correct before the hardware tears loose.
Our Sliding & Patio Doors Process - Step by Step
- 1
We take the call and listen. A live person answers, day or night. We ask what the door is doing, what brand it is, and how long it has been acting up. That conversation tells us which parts and tools belong on the truck, which means most repairs happen on the first visit.
- 2
We measure, check the frame, and show you what we found. Every opening is measured twice. Our technicians check the panel for plumb, the track for wear, the rollers for flat spots, and the frame for settlement. We carry a straightedge and level on every job, and we will point to what is actually wrong before recommending a fix.
- 3
You get a written quote before any work begins. We put the price on paper, line by line, with the manufacturer line named. No surprise line items appear later. If a repair and a replacement are both reasonable options, we lay both out so you can decide with the numbers in front of you.
- 4
We do the work right, on the schedule we promised. Uniformed, background-checked technicians do the work the way they would in their own mother’s house. We replace worn parts, adjust the panel, and test the door through a full cycle of opens and closes before we call the job done.
- 5
We register both warranty layers before we leave the driveway. That is The Keystone Standard: manufacturer warranty layers registered in writing, durations stated, and our Done Right Promise on top. If something is not right, we make it right, with no paperwork fights and no arguing.
How Much Does Sliding & Patio Doors Cost in Stuart?
What moves the price is panel weight, track condition, frame squareness, and whether the door is a standard size or a custom cut. A door that has been forced for years may need new hardware plus a track and frame correction, which costs more than a simple roller swap. The way to avoid overpaying is to get a written line-item quote that names the parts and the labor separately, which is what we provide on every visit. Our free estimates include the measurement, the diagnosis, and the price on paper, so you know exactly what the job costs before you approve it. Call (754) 324-4646 to schedule yours.
Sliding & Patio Doors Near Stuart - Our Service Area
We work throughout Stuart and the surrounding communities, including Palm City, Sewall’s Point, Port Salerno, Jensen Beach, Hobe Sound, White City, and up into Port St. Lucie and Fort Pierce. We are also the crew to call for Sliding & Patio Doors in Hobe Sound when the salt air along the coast has eaten a track or seized a set of rollers, and we handle Sliding & Patio Doors in Jensen Beach for homeowners whose sliders face the ocean breeze every afternoon. Most Stuart calls see a technician the same day, and scheduling is always done with a live person, not a callback system. That is part of how we have home service rooted in more than four decades of showing up when we say we will.
Serving Stuart, FL - Our Local Coverage Area
We’re based in the Stuart area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Sliding & Patio Doors in Stuart
What is sliding and patio door service?
Sliding and patio door service covers repair, replacement, installation, and adjustment of the doors that open horizontally along a track. That includes roller replacement, track repair, lock alignment, weatherstripping replacement, glass replacement, and full door installation. In Stuart, it also means dealing with the specific wear that salt air and humidity put on frames, rollers, and seals.
How long does a sliding door repair or replacement take?
Most sliding door repairs are finished in a single visit, usually within an hour or two depending on what we find. A full replacement of a standard slider typically takes half a day including removal, installation, and cleanup. Panoramic multi-panel systems can take a full day or more, and we will tell you the timeline in writing before we start.
How much does sliding door repair cost in Stuart?
Typical repairs run $180 to $400, while full door replacements start around $1,800 and climb with impact ratings and custom sizing. The exact number depends on the panel weight, the track condition, and whether the frame is still square. Call (754) 324-4646 for a free estimate with a written, line-item quote so there are no surprises.
Do you service PGT, CGI, Ply Gem, and CWS doors?
Yes. We service PGT, CGI, Ply Gem, and CWS sliding and patio doors, and we are an authorized installer for PGT and CGI. We stock common service parts for those lines on the truck, which means fewer return trips. If your door is another brand, we service it too, because most sliding door failures are hardware issues that follow the same patterns across manufacturers.
Do you offer emergency sliding door service in Stuart?
Yes. A live person answers the phone 24 hours a day, seven days a week. If a slider has come off its track and left your home unsecured, or if a panel has cracked and you cannot close the opening, call (754) 324-4646 and we will get a technician to you as fast as the schedule allows.
What warranty do you provide on sliding door work?
Every job is covered by the Done Right Promise: if it is not done right, we make it right, with no paperwork fights and no arguing. On top of that, The Keystone Standard means both manufacturer warranty layers are registered in writing before our truck leaves your driveway, and we tell you the durations in plain English.
How do I prepare for a sliding door repair or replacement?
Clear the area about six feet in front of the door, both inside and out, and move any furniture or plants that sit in the work path. If you have pets, keep them in another room while we work. We bring drop cloths and clean the work area before we leave, but a clear path helps us move the glass safely and keeps the job on schedule.
Schedule Your Sliding & Patio Doors Service in Stuart Today
If your sliding door is sticking, leaking, or leaving daylight in the frame, call us. A live person answers at (754) 324-4646, day or night, and your estimate is free. We will measure, diagnose, and put the price on paper before any work begins, and we will stand behind the job with our Done Right Promise. The door either glides true or we are not finished.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Stuart since 2008.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.